Motors, gearboxes and drives sizing
Sizing motors, gearboxes and drives: torque, speed, inertia matching and duty cycle.
Latest articles
Explainer
Checking Servo Speed Margin for a Rack and Pinion Axis
Speed here is kinematics, not tuning: 875 ipm through a 30:1 reducer and a 2-inch pitch-diameter pinion takes about 4,178 motor rpm against a 4,200 rpm ceiling, leaving 22 rpm of margin. Cap the ratio near 24:1, or fit a pinion near 2.5 in pitch diameter, so the motor runs at 80% of rated speed at full feed; the torque budget easily follows.
Selection guide
Choosing an Actuator to Compress a Small Spring Precisely
A 2 lbf (8.90 N) spring over 0.5–0.75 in of travel at 0.025 in steps is a screw problem, not a motor problem: a manual fine-lead screw with a locknut holds the setting with no power. Add a stepper only for remote adjustment, an integrated actuator for automated sequences, or a pneumatic cylinder with an adjustable stop when only endpoint positions matter.