Pneumatics and hydraulics
Cylinders, air preparation and hydraulic circuits: sizing, speed control and leaks.
Latest articles
Selection guide
Selecting a 180 Degree Helical Rotary Pneumatic Actuator
Yes, purpose-built 180-degree pneumatic rotary actuators exist as catalog items from several makers. Size one from the worst-case load torque measured at the driven shaft and the pressure measured at the actuator ports during motion. Doubling rotation in the same helical housing halves ideal torque, so never stretch a 90-degree rating to 180 degrees.
Explainer
Can a PLC Servo Valve Stop a Hydraulic Ram Repeatably
No — not on a PLC analog output alone. Oil compressibility, load and valve null drift move an open-loop stop, so the loop must close on a ram-mounted transducer, which a Delta Motion note says can position heavy loads to better than 0.0005 in. Decide by measuring today's stopping spread against the part tolerance: if the stop switch meets it, modernize the servo positioner and keep the manual fallback.
Troubleshooting
Tracing Lathe Chuck Cylinder Vibration Above 2300 RPM
A rear-mounted rotating chuck cylinder that shakes above 2300 rpm is unbalance or runout until the checks say otherwise. Hold adapter and cylinder runout under 0.0005 in TIR — a 0.015 in TIR reading at the sensor end is thirty times that — and check mounting-bolt burrs, draw-tube threads and clamp pressure before condemning spindle bearings.
Comparison
Stopping a Vertical Air Cylinder on a Light Curtain Trip
Use a 3-position center-pressurized valve with a higher regulated rod-side pressure — the only pneumatic center that balances a vertical load mid-stroke — then let a rod lock hold it. Verify every component in the trapped-air path against the deceleration pressure spike and confirm total stop time against the safety-distance formula Ds = 63 in/s × Ts.
Comparison
Electric vs pneumatic butterfly valve actuator comparison
Choose a modulating electric actuator when the valve must hold set positions between open and closed under a digital command and you would rather not run compressed air to it; choose pneumatic when the 90° stroke must finish in one to three seconds, when the process needs a spring-driven fail-safe action, or when the valve sits somewhere an electric drive would need certified explosion-proof construction. Size either type to exceed the valve's break torque by at least 25% at minimum supply pressure, on an ISO 5211 mounting interface.
How-to
Sizing a Hydraulic Cylinder Bore for a Linked Lift
Size the bore from the maximum cylinder force the elbow linkage demands anywhere in the travel, not from the 2,000 lb payload. With the modeled 4,000 lbf breakaway demand and 2,175 psi of working pressure, the minimum bore is sqrt(4 x 4,000 / (pi x 2,175)) = 1.53 in, so specify a two-inch bore, good for 6,833 lbf at that pressure. Flow, rod buckling and heat are separate checks.
Selection guide
Pneumatic valve setup for double-acting robot grippers
One 5/3 double-solenoid valve with a chosen center runs a single double-acting gripper cylinder: coil A closes, coil B opens, both off gives the idle state you ordered. Two spring-return valves on one manifold usually feed two functions — equalization, safety lock, cascaded exhaust — not one cylinder. Size the valve on peak flow: the worked example needs about 264 L/min at close.